Roof Opening Panel Motor Initialization

The roof opening panel motor initialization procedure must be done when repairs are carried out on part of the roof opening panel system including.

Roof opening panel motor initialization.

The roof opening panel glass will move to the full vent position then back to closed initialization movements. Quickly release and re press and hold the slide switch. Any time the roof opening panel motor has been removed from the roof opening panel assembly a new roof opening panel motor has been installed or when a new roof opening panel assembly has been installed. If your sunroof is broken or making a popping snapping noise this won t f.

The roof opening panel assembly has been removed from the vehicle. The roof opening panel will cycle slightly rearward and then slightly forward to the stored open position. Refer to workshop manual section 501 17. A new roof opening sliding glass or power shade motor has been installed.

The roof opening panel glass has been removed from the roof opening panel system. Initialize reset or reprogram a 2015 18 f 150 s 350 s vista sunroof note. 2017 escape vehicles equipped with power roof opening panel built on 06 jun 2016 and through 03 dec 2016 have a change to the initialization procedure for both the roof opening panel and the shield sunshade. Assembly a new roof opening panel motor has been installed or when a new roof opening panel assembly has been installed.

Turn the ignition to the run position. The roof opening panel does not open or close properly note. The roof opening panel motor s must be initialized when repairs are carried out on any part of the roof opening panel system including whenever the roof opening sliding glass or power shade motor has been removed from the roof opening panel system. For a new roof opening panel motor proceed to step 2.

For an existing roof opening panel motor skip to step 3.